workbench kit | Workbench Outfeed table is looking good

workbench kit

I finally took some pictures of the table today after I finished putting the trim around the edges. It really looks good and I am proud of it. Its a great work surface and is very study and stable.
I trimmed the top edge with some Douglas Fir 1x that was ripped down to the width of the table top. I fastened it with some odinary drywall screws and wood glue, countersinking every screw so that I can come back and put some dowels in the holes to clean it up a bit. Be sure not to over tighten the screws when your attaching these and I put on plenty of glue expecting the MDF to soak it right up.
I still plan on putting a vice on the right end of the table and I am going to have to order some leveling legs for it because what I had planned for legs just didnt work out (some threaded shafts and a couple nuts).

Do you find information about workbench kit are you looking for? If not, below may help you find more information about the workbench kit. Thank you for visiting, have a nice day.

 

Related Posts by Categories