workbench legs
Here it is ready for some glue.
I put on a generous amount of glue, put the second piece on, put in some 1" screws in the middle and then clamped the hell out of it. I am hoping that this will make the top conform to the 2x4s underneath.
Yep, I used almost all of my clamps for this!
I cut the tray bottom down to its finish size on the table saw.
I set my dado stack for 1/2" wide and 1/4" deep.
I set the fence to cut a groove 3" from the top of the board.
The grooves have been cut!
I think that I am going to have to notch the plywood bottom for the tool tray.
I marked the notch on the plywood
and cut it out with my cordless jigsaw that I totally suck at using.
Do you find information about workbench legs are you looking for? If not, below may help you find more information about the workbench legs. Thank you for visiting, have a nice day.
0 komentar:
Posting Komentar