best workbench plans | Scotts 21st Century Bench

best workbench plans

I got a few emails from Scott Cardais from North Carolina, who recently endeavored to build his own 21st Century workbench.  For those that have been following my blog from the beginning, that was the first video project I did on this site (you can access the full set of episodes here).  I think he did a fantastic job, so I wanted to share the results.  Here is what Scott had to say.

Rob:

Three pictures of the bench before applying any kind of finish are attached. I think it turned out pretty good. Better than I expected!

I decided not to build the drawers (trays) per the plans; at least not until Ive used the bench for a few projects. At this point, the space between the two glue ups is filled with 2 plywood boards with sides so they can be turned over to create a solid top. Ill use it this way for a while to see if I want to make any changes.  For the same reason, I havent finished drilling all the dog holes. I wanted to use the bench for a few projects before drilling too many, perhaps unnecessary, holes.

The bench is 30" wide by 89" long by 34" tall and its very, very solid.  (Note: the pipe clamps on the lower stretchers are just being stored there! Theyre not holding it together!)

The joinery was done with a combination of power and hand tools.

I used a dado set for the half laps and a contractors saw to rips the boards to width and an old, circa 1950, 6" Rockwell joiner to square the edges and faces of the top. What a pain! Most of the cross cuts were done on my 12" sliding miter saw. After hollowing out most of the mortises on the drill press, I finished with chisels and files. I cut the tenons and dovetails by hand using a japanese saw.

For what its worth, I think it took me about 12 days to build. Its made of solid ash from 8/4 stock which cost $2.70 bd ft locally (Asheville, NC). I think the total cost of the wood and supplies was about $700 (including $250 for the twin screw vise). The lamination of the two tops was probably the hardest part because I struggle with milling stock perfectly square; even with a power jointer and because theyre heavy. It was difficult to maneuver them into the thickness planer and miter saw.

The joinery wasnt too difficult. I was surprised. Drilling the holes for the twin screw vise was a pain because Ive got a small, table top Delta drill press with too little power and too little travel. Just drilling the darn 1 1/2" holes for the twin screws probably took 1 1/2 hours.

All kidding aside, your video blog posting is what inspired me to try this so Thank You.

Best regards,

Scott

Do you find information about best workbench plans are you looking for? If not, below may help you find more information about the best workbench plans. Thank you for visiting, have a nice day.

 

Related Posts by Categories